GPS and return-to-home features reduce workload only when setup, location data and operating conditions are correct. This workflow separates checks that belong before travel, at the launch site and immediately before takeoff.
Reference Photos


Before leaving home
Read the exact aircraft and app manuals, inspect propellers and batteries, confirm storage capacity, and download any maps or firmware needed. Do not install an untested update immediately before an important flight.
At the launch site
Check airspace and site permission using current local sources. Look for magnetic interference, obstacles, people, wildlife and a safe emergency landing area. Set altitude and distance limits appropriate to the site and applicable rules.
Calibration and position checks
Calibrate only when the manufacturer or app instructs you to do so. Confirm the reported home point, satellite status, compass and inertial warnings before takeoff. Move the aircraft if interference persists.
A controlled first minute
Hover at a low safe height, verify control response and watch for drift or warnings. Do not test return-to-home over people or near obstacles. Land if position hold is inconsistent.
Quick decision checklist
- Identify the exact aircraft model and revision.
- Use the manufacturer manual as the controlling source.
- Stop when damage, warnings or unexpected behavior appears.
- Document any measured result and the test conditions.
See the drone collection and confirm model-specific functions on the L900 Pro drone page before adapting this general checklist.